$1,950.00
This course uses classroom and laboratory exercises to build a foundation in industrial measurement and control.
The basic concepts of pressure, level, flow, temperature, reading and interpreting basic piping and instrument drawings (P&ID) are included.
Students will calibrate transmitters and test measurement loops.
TOTAL HOURS 40
PREREQUISITES None
LOCATION Crown Training and Development, Merrillville, IN
$1,950.00
This course covers installation, calibration, and maintenance of measurement devices.
An examination of the devices used in measurement and control systems, such as PID (Proportional, Integral, and Derivative) controllers, transmitters, transducers, and recorders are covered.
Topics include: loop characteristics, test equipment, calibration, and configuration, maintenance and installation, working in hazardous locations, and trends. Reading and interpreting advanced Piping and Instrument Drawings (P&ID) will also be included.
TOTAL HOURS 40
PREREQUISITES Basic Instrumentation
LOCATION Crown Training and Development, Merrillville, IN
$950.00
This is a two-day class designed to improve your ability to read and interpret piping and instrument diagrams.
Topics include: the importance of P&IDs, identifying and describing the parts of a typical P&ID, using a legend sheets to identify symbols and labels used in a P&ID, explanation of instrument and control loops, redlining and marking-up a P&ID, submitting redlines and verification of corrected P&IDs.
TOTAL HOURS 16
PREREQUISITES None
LOCATION Crown Training and Development, Merrillville, IN
$1,350.00
This course presents an introduction to Weighing Systems.
The following topics are covered: Tension strain gage load cells, motion weighing, how a load cell works, how to troubleshoot load cell and weighing systems, calibration methods, and how Handbook 44 applies to weighing systems.
TOTAL HOURS 24
PREREQUISITES None
LOCATION Crown Training and Development, Merrillville, IN
$1,950.00
This course reviews and then build upon the concepts of proportional, integral and derivative control with advanced topics such as cascade, ratio and feed-forward control being covered.
Various methods of controller tuning are reviewed and practiced. Control loop troubleshooting techniques for single-loop and multi-loop systems are included. A review of reading and interpreting advanced Piping and Instrument Drawings (P&ID) is also covered.
TOTAL HOURS 40
PREREQUISITES Basic Instrumentation and Troubleshooting & Applied Instrumentation
LOCATION Crown Training and Development, Merrillville, IN